|
|
Electric Motor Control, 9th Edition by Stephen L. Herman
Book's Contents
Unit 1: General Principles of Electric Motor Control.
Unit 2: Fractional and Integral Horsepower Manual Motor Starters.
Unit 3: Magnetic Line Voltage Starters.
Unit 4: Symbols.
Unit 5: Interpretation and Application of Simple Wiring and Elementary Diagrams.
Unit 6: Push Buttons and Control Stations.
Unit 7: Relays.
Unit 8: Contactors.
Unit 9: Timing Relays.
Unit 10: Pressure Switches and Regulators.
Unit 11: Float Switches.
Unit 12: Flow Switches.
Unit 13: Limit Switches and Proximity Control.
Unit 14: Phase Failure Relays.
Unit 15: Solenoid Valves.
Unit 16: Temperature Switches.
Unit 17: Two-Wire Controls.
Unit 18: Three-Wire and Separate Controls.
Unit 19: Hand-Off-Automatic Controls.
Unit 20: Multiple Push Button Stations.
Unit 21: Interlocking Methods for Reversing Control.
Unit 22: Sequence Control.
Unit 23: Jogging (Inching) Control Circuits.
Unit 24: Time-Delay, Low-Voltage Release Relay.
Unit 25: The Motor and Starting Methods. Unit 26: Primary Resistor-Type Starters.
Unit 27: Auto transformer Starters.
Unit 28: Part Winding Motor Starters.
Unit 29: Automatic Starters for Star-Delta Motors.
Unit 30: AC Solid-State Reduced Voltage Controller.
Unit 30: AC Solid-State Reduced Voltage Controller.
Unit 31: Controllers for Two-Speed, Two-Winding (Separate Winding) Motors.
Unit 32: Two-Speed, One-Winding (Consequent Pole) Motor Controller.
Unit 33: Four-Speed, Two-Winding (consequent Pole) Motor Controller.
Unit 34: Wound Rotor Motors and Manual Speed Control.
Unit 35: Push Button Speed Selection.
Unit 36: Automatic Acceleration for Wound Rotor Motors.
Unit 37: Automatic Speed Control for Wound Rotor Motors.
Unit 38: Solid-State Adjustable Speed Controller for AC Wound Rotor Motors.
Unit 39: Synchronous Motor Operation.
Unit 40: Push Button Synchronizing.
Unit 41: Timed Semiautomatic Synchronizing.
Unit 42: Synchronous Automatic Motor Starter.
Unit 43: About DC Motors.
Unit 44: Use of Reduced Voltage for Starting.
Unit 45: Across-the-Line Starting.
Unit 46: Compensating and Definite Time Control Starting.
Unit 47: Solid-State Adjustable Speed Control.
Unit 48: Plugging.
Unit 49: Electric Brakes.
Unit 50: Dynamic and Regenerative Braking.
Unit 51: Electric and Electronic Braking.
Unit 52: Direct Drives and Pulley Drives.
Unit 53: Gear Motors.
Unit 54: Variable-Frequency Mechanical Drives.
Unit 55: AC Adjustable Frequency Drives.
Unit 56: Magnetic Clutch and Magnetic Drive.
Unit 57: DC Variable-Speed Control - Motor Drives.
Unit 58: Programmable and Motion Control.
Unit 59: Motor Startup and Troubleshooting Basics.
Unit 60: Troubleshooting Techniques.
-->
Download Instruction
1-Click on the link
2-Wait for five seconds and then click on 
0 Comments:
Post a Comment